Evaluation of weight loss and surface roughness of compomers after simulated toothbrushing abrasion test

Abstract

This study aimed at analyzing the compomers wear by an "in vitro" toothbrushing abrasion test. The null hypotheses tested were that there would be no differences in weight loss and no significant changes in surface roughness of the compomers after this test. The utilized commercial brands were Dyract (Dentsply), Dyract AP (Dentsply), Compoglass F (Vivadent), Freedom (SDI), F2000 (3M ESPE), which were compared to the two resin composites Z100 (3M ESPE) and Silux Plus (3M ESPE). Ten cylindrical specimens for each commercial brand were prepared with 5mm diameter and 3mm thickness. An appropriate machine with soft bristle tips containing dentifrice solution and deionized water was used. A total of 100,000 brushing cycles were performed. The amount of weight loss was measured by the percentage alteration between the initial (before toothbrushing) and final weight (after toothbrushing), measured by a Sartorius analytical balance. The surface roughness change was determined by the percentage difference between initial and final means after 5 tracings by a T 1000 Hommel Tester roughness meter on the specimen's surfaces before and after toothbrushing abrasion test. The statistical analysis (Students paired t-test, ANOVA and Tukey, á=0.05) showed that all materials presented statistically significant weight loss and roughness increase after abrasion test. All compomers presented higher weight loss than resin composites. Freedom and Dyract AP presented the lowest weight loss among compomers. F2000 presented the worst abrasion resistance, without statistical differences with Dyract. For roughness changes, Dyract, Dyract AP, Z100, Compoglass F and Silux Plus showed the lowest surface roughness alteration, in increasing order, without statistical differences between them. Freedom was the statistically roughest material of the study.