Effect of repeated immersion solution cycles on the color stability of denture tooth acrylic resins

Authors

  • Paulo Maurício Batista da Silva University of São Paulo; Bauru School of Dentistry; Department of Prosthodontics
  • Emílio José Tabaré Rodríguez Acosta University of São Paulo; Bauru School of Dentistry; Department of Prosthodontics
  • Matheus Jacobina University of São Paulo; Bauru School of Dentistry; Department of Prosthodontics
  • Luciana de Rezende Pinto University of São Paulo; Bauru School of Dentistry; Department of Prosthodontics
  • Vinícius Carvalho Porto University of São Paulo; Bauru School of Dentistry; Department of Prosthodontics

DOI:

https://doi.org/10.1590/S1678-77572011000600013

Keywords:

Disinfectants, Polymethyl methacrylate, Color perception tests

Abstract

OBJECTIVE: Chemical solutions have been widely used for disinfection of dentures, but their effect on color stability of denture tooth acrylic resins after repeated procedures is still unclear. The aim of this in vitro study was to evaluate whether repeated cycles of chemical disinfectants affected the color stability of two denture tooth acrylic resins. MATERIAL AND METHODS: Sixty disc-shaped specimens (40 mm x 3 mm) were fabricated from two different brands (Artiplus and Trilux) of denture tooth acrylic resin. The specimens from each brand (n=30) were randomly divided into 6 groups (n=5) and immersed in the following solutions: distilled water (control group) and 5 disinfecting solutions (1% sodium hypochlorite, 2% sodium hypochlorite, 5.25% sodium hypochlorite, 2% glutaraldehyde, and 4% chlorhexidine gluconate). Tooth color measurements were made by spectrophotometry. Before disinfection, the initial color of each tooth was recorded. Further color measurements were determined after subjecting the specimens to 7, 21, 30, 45, 60, and 90 immersion cycles in each tested solution. Color differences (ΔE*) were determined using the CIE L*a*b* color system. Data were analyzed using two-way repeated measures analysis of variance (ANOVA) followed by Tukey tests. The significance level was set at 5%. RESULTS: There were statistically significant differences in ΔE* among the 5 disinfectants and water during the 90 cycles of immersion for both denture tooth acrylic resins. Distilled water promoted the greatest color change in both denture tooth acrylic resins, nevertheless none of tested disinfectants promoted ΔE* values higher than 1.0 on these acrylic materials during the 90 cycles of disinfection. CONCLUSIONS: Repeated immersion cycles in disinfecting solutions alter ΔE* values, however these values do not compromise the color of the tested denture tooth acrylic resins because they are imperceptible to the human eye.

Downloads

Download data is not yet available.

Downloads

Published

2011-12-01

Issue

Section

Original Articles

How to Cite

Effect of repeated immersion solution cycles on the color stability of denture tooth acrylic resins . (2011). Journal of Applied Oral Science, 19(6), 623-627. https://doi.org/10.1590/S1678-77572011000600013